User's Manual Part 2

Exciter Configuration Description - 66 -
®
Affinity LBD-200C-N1 Transmitter
Product Manual
DC Power Requirements / Synthesizer Specifications
The module requires a single 12VDC source entering on pin B10 of the 60-pin DIN connector.
Parameter Specification Comments / Notes
Voltages / Currents
+12 V
DC
r.5 @ 850mA max.
+12 V
DC
r.5 @ 1.5A max.
w/o internal reference
w/ internal reference
Ripple <1mV Pk-Pk Allowable on external source
Connector DIN41612 type M connector. 60
conductor, 2amp / circuit; performance
level 1
Interfaces to back-plane
Reference Specifications (applies to external reference except where indicated)
Parameter Specification Comments / Notes
Frequency 10MHz External or optional internal
Input Level 0 dBm +15 /-5dB (+48 dBmV nominal) +30dBm no damage
Format Sinusoidal
Stability vs. temp.
External MRO
Internal OCXO
1x10
-7
PPM minimum 0q-50qC
r2x10
-8
PPB minimum 0q-50qC
After 60 minute warm up; Refer
to Temex
specification/datasheet for long
term ageing specifications
(valid for free-running mode
only)
Non-Harmonic
Spurious
10Hz < ƒ
offset
< 5MHz < -104dBc
beyond 5MHz < 75dBc
Connector /
Impedance
DIN connector coaxial contact / 50 :
For external input and internal
output; Mates with back-plane
connector