User's Guide

Program Operation 17
Affinity Control User’s Guide
Software v2.50
The screen shown in Figure 19
displays a "last chance" warning
message. Clicking on the Next
button in this screen will erase any
previous parameters stored in the
upconverter and initialize it using
default values. Clicking on the
Cancel button will terminate the
procedure without any changes
being made to the upconverter
settings.
Figure 19 Full Calibration-"Last Chance" Warning
The screen in Figure 20 displays a
wait message while the upconverter
is initialized with the pre-calibration
default values. Note that the
initialization can take a few minutes
– Be patient.
Figure 20 Full Calibration-Upconverter Initialization