User's Guide

Program Operation 10
Affinity Control User’s Guide
Software v2.50
Upconverter Parameter Settings
Saved: May 19, 2004 at 11:03:31
--------------------------------------------------
SETUP/CONFIGURATION INFORMATION
--------------------------------------------------
Date of last Setup/Config Change: 2004-05-19, 08:43:26
Affinity Control SW v2.18
Configured COM Port: 2, COM Timeout: 5000ms
System Pwr Level: 500W, Amp Count: 8
Power Alarms Enabled
Fwd Pwr Alarm Low: 95, Fwd Pwr Alarm High: 105
Upconverter Pwr Alarm Low: 90, Upconverter Pwr Alarm High: 110
--------------------------------------------------
UPCONVERTER PARAMETERS INFORMATION
--------------------------------------------------
Upconverter Firmware Version: 1.10
System Fwd Pwr: 102
Sys Rev Pwr: 0
Upconverter Fwd Pwr: 105
Temperature: 197
Health Mask: 0xFF7B
Health Reading: 0xFFFF
Health Snapshot: 0xFFBF
Personality: 0xFFFF
FW State: 4
FW Mode: 1
In Signal: 0
Current Channel: 21
Stored Channel: 21
--------------------------------------------------
CALIBRATION VARIABLES
--------------------------------------------------
ALC_AUTO_REF_MIN: 0
ALC_AUTO_REF: 669
ALC_MANUAL_REF: 1325
SYS_FWD_PWR_REF: 567
SYS_REFLECTED_PWR_REF: 565
UPCONVERTER_INT_FWD_PWR_REF: 577
FAST_REFLECTED_SHUTDOWN_THRESHOLD: 920
FAST_REFLECTED_PWR_PERCENT_LIMIT: 20
POWER_LIMITER: 430
FILTER_COEFF_1: 7
FILTER_COEFF_2: 7
AGC_AUTO_REF_MIN: 4095
AGC_AUTO_REF: 4095
AGC_MANUAL_REF: 4095
IF_THRESHOLD: 4095
FREQ_RESP_1: 4095
FREQ_RESP_2: 4095
--------------------------------------------------
Miscellaneous Readings
--------------------------------------------------
SYS_FWD_PWR_ADC: 568
SYS_REFLECTED_PWR_ADC: 264
UPCONVERTER_PWR_ADC: 579
OUTPUT_AMP_CURRENT: 48
FINAL_AMP_CURRENT: 71
--------------------------------------------------
END OF DATA
--------------------------------------------------
Figure 10 Saved Upconverter Settings File Example