MSDS

4181-
page 2 of 3
SPECIAL FIRE FIGHTING PROCEDURES
Full protective equipment including self-contained breathing apparatus should be used.
Water spray may be ineffective. If water is used, fog nozzles are preferable. Water may be used to cool closed containers to prevent pressure
build-up and possible autoignition or explosion when exposed to extreme heat.
SECTION 6 — ACCIDENTAL RELEASE MEASURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
Remove all sources of ignition. Ventilate the area.
Remove with inert absorbent.
SECTION 7 — HANDLING AND STORAGE
STORAGE CATEGORY
Not Applicable
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE
Keep container closed when not in use. Transfer only to approved containers with complete and appropriate labeling. Do not take internally.
Keep out of the reach of children.
SECTION 8 — EXPOSURE CONTROLS/PERSONAL PROTECTION
PRECAUTIONS TO BE TAKEN IN USE
Use only with adequate ventilation.
Avoid contact with skin and eyes. Avoid breathing vapor and spray mist.
Wash hands after using.
This coating may contain materials classified as nuisance particulates (listed "as Dust" in Section 2) which may be present at hazardous
levels only during sanding or abrading of the dried film. If no specific dusts are listed in Section 2, the applicable limits for nuisance dusts
are ACGIH TLV 10 mg/m3 (total dust), 3 mg/m3 (respirable fraction), OSHA PEL 15 mg/m3 (total dust), 5 mg/m3 (respirable fraction).
Removal of old paint by sanding, scraping or other means may generate dust or fumes that contain lead. Exposure to lead dust or fumes may
cause brain damage or other adverse health effects, especially in children or pregnant women. Controlling exposure to lead or other
hazardous substances requires the use of proper protective equipment, such as a properly fitted respirator (NIOSH approved) and proper
containment and cleanup. For more information, call the National Lead Information Center at 1-800-424-LEAD (in US) or contact your
local health authority.
VENTILATION
Local exhaust preferable. General exhaust acceptable if the exposure to materials in Section 2 is maintained below applicable exposure
limits. Refer to OSHA Standards 1910.94, 1910.107, 1910.108.
RESPIRATORY PROTECTION
If personal exposure cannot be controlled below applicable limits by ventilation, wear a properly fitted organic vapor/particulate respirator
approved by NIOSH/MSHA for protection against materials in Section 2.
When sanding or abrading the dried film, wear a dust/mist respirator approved by NIOSH/MSHA for dust which may be generated from this
product, underlying paint, or the abrasive.
PROTECTIVE GLOVES
Required for long or repeated contact.
EYE PROTECTION
Wear safety spectacles with unperforated sideshields.
SECTION 9 — PHYSICAL AND CHEMICAL PROPERTIES
PRODUCT WEIGHT
8.56 lb/gal 1025 g/l
SPECIFIC GRAVITY
1.03
BOILING POINT
212 - 213 °F 100 - 100 °C
MELTING POINT
Not Available
VOLATILE VOLUME
79%
EVAPORATION RATE
Slower than
ether
VAPOR DENSITY
Heavier than air
SOLUBILITY IN WATER
Not Available
pH
8.5
VOLATILE ORGANIC COMPOUNDS (VOC Theoretical - As Packaged)
0.29 lb/gal 35 g/l Less Water and Federally Exempt Solvents
0.06 lb/gal 7 g/l Emitted VOC
SECTION 10 — STABILITY AND REACTIVITY
STABILITY — Stable
CONDITIONS TO AVOID
None known.