Instructions / Assembly

 Be sure that both surface and air temperature are above 50°F during
application and for 48 hours after application. Do not apply product if rain is
forecasted within 24 hours of application.
 Perform the splash test. Sprinkle water on various sections of surface to be
sealed. If water absorbs and darkens color of surface within five seconds,
surface is porous and considered ready to be treated. If water beads up or
otherwise sits on top of surface, then surface does not need protection at
this time.
 Cover plants and shrubs. Move all objects that could come in contact with
overspray. Overspray of product onto glass should be removed
immediately with paint thinner or mineral spirits.
 Do not use in below grade application where water pressure is a problem
or on painted or recently stained surfaces.
SURFACE PREPARATION
 WARNING! If you scrape, sand, or remove old paint, you may release
dust. LEAD IS TOXIC. Contact the National Lead Information Hotline at 1-
800-484-LEAD (in US) or contact your local health authority.
 Surfaces and substrates must be free of all mildew stains, dust, dirt, oil,
soot, grease and other contaminants.
 If surface is damp or wet from cleaning or weather, always allow the
surface to dry thoroughly (a minimum of 48 hours) before application.
CLEANING PRODUCTS
 To prevent clogs, hold can upside down and spray until clear gas appears.
 To clean stain on dial, wear eye protection, and wipe off with mineral
spirits. DO NOT stick pin in dial opening.
 Clean overspray with mineral spirits following manufacturer’s instructions.
APPLICATION
 Use outdoors in a well ventilated area.
 A small trial patch should be tried before application over the entire
surface.
 Shake can 1-2 minutes before and occasionally during use.
 Hold can in upright position 8"-12” from surface.