Manual

Assembly And Loading Of

T/C Break-O-Way

™

Sabots

When loading T/C’s Break-O-Way Sabots, make sure that your gun is

unprimed, and that your Break-O-Way Sabot has been properly assem-

bled. Failure to assemble and load your sabot correctly could result in the

bullet, sabot halves, or woven wool doughnut separating and disengaging

from themselves. This could result in an air space between the compo-

nents. Under such a condition, one or more of the components may act

as a barrel obstruction and firing can result in a damaged firearm and

POSSIBLE INJURY OR DEATH TO THE SHOOTER OR BYSTAND-

ERS AND DAMAGE TO PROPERTY.

To properly assemble your T/C Break-O-Way Sabot, position 2 sabot

halves together forming a complete sabot cup. Press the woven wool “dough-

nut” firmly on the base, allowing the flange to protrude through the hole. Your

sabot is now ready to accept a .429" - .430" diameter .44 cal bullet. Use only

bullets of these dimensions.

Use only bullets measuring .429" - .430" designed for use in .44 caliber pis-

tols or rifles. Using bullets of lesser diameter may cause the bullet to sep-

arate from the sabot resulting in a barrel obstruction. Using bullets of larg-

er diameter could result in difficult loading, or a condition where the sab-

ot is not seated all the way down in the powder charge, resulting in a bar-

rel obstruction. Either case can result in a damaged firearm and POSSI-

BLE INJURY AND/OR DEATH TO THE SHOOTER OR BYSTANDERS

AND DAMAGE TO PROPER

The photo on page 31 pictures a shooter in the process of loading a muz-

Assembled

Sabot

Woven Wool

"Doughnut"

Sabot

Halves

.429" to .430"

Bullet