Manual

26
this, turn the Elevation Adjustment Lock Screw counterclockwise (as viewed
from the top) and slide the blade carrier up the ramp to raise the point of
impact, and down the ramp to lower the point of impact. Retighten the lock
screw after you make your adjustment and before you fire.
To adjust the windage it is necessary to move the rear sight leaf left or right in
its slot. After loosening the Windage Lock Screw by turning it counterclockwise
(as viewed from the top), move the rear sight blade in the direction you want
your shots to hit-- (Example; move the sight blade to the right to move your
shots to the right and to the left to move the shots to the left). Retighten the
lock screw after you make your adjustment and before you fire.
Diagram A
Mounting A Scope
On The T/C 22 LR Classic
The receiver is factory drilled and tapped for a T/C scope mount base. The
Weaver-Style Mounts which are appropriate for this rifle are T/C Part No.9951
Follow the instructions that came with your scope mounts for proper mounting
of your scope. Questions should be addressed to our Service Department, at
Telephone #[phone].
Make sure the T/C 22 LR Classic is unloaded, with the action open before
adjusting the rear sight or mounting a scope. AN ACCIDENTAL DIS-
CHARGE CAN CAUSE INJURY AND/OR DEATH TO THE SHOOTER
OR BYSTANDERS AND DAMAGE TO PROPERTY.
Custom Alterations
& Conversions
Thompson/Center 22 LR Classic Rifles which are subjected to custom alter-
ations or conversion other than those performed by the Thompson/Center
Custom Shop are not covered by our warranty. Thompson/Center does not
Elevation
Lock
Screw
Windage
Lock
Screw