Manual

10
Assembly & Disassembly
Of The System 1
™
This System 1 has three (3) basic parts groups:
1. The Barrel Assembly
- This assembly includes the barrel, breech plug with
nipple, ramrod, thimbles and sights. It is held to the receiver by a takedown
bolt which anchors the barrel lug to the receiver lug.
3. The Receiver/Striker/Trigger Assembly - This assembly is held in the
stock by two screws; one located at the rear of the trigger guard and the other
is the front trigger guard screw on those models with a walnut stock. On those
models with a composite stock, the second screw is just in front of the trigger
guard. The striker assembly is housed in the receiver, under spring tension. It
is secured by the large receiver end cap at the rear end of the receiver.
2. The Stock Assembly (with trigger guar
d)
- This includes the stock itself
with sling swivel studs attached and a butt pad. The diagram above shows the
walnut stocked version.
Front Sight
Rear Sight
Barrel
Thimble Ramrod
Nipple
Breech Plug
Takedown Bolt
Barrel
Lug
Receiver
End
Cap
Striker 
Spring
Striker 
Handle
Retainer
Striker 
Handle
Striker
Safety
Receiver
Receiver
Lug
Trigger
Trigger
Guard
Butt Pad
Walnut Stock
Models
(2) 
Trigger Guard
Screws
Red Dot 
marks "Fire" 
Position
Green Dot 
marks "Safety" 
Position