Manual

56
Assembly And Loading Of
T/C Break-O-Way
™
Sabots
When loading T/C’s Break-O-Way Sabots, make sure that your gun is unprimed,
and that your Break-O-Way Sabot has been properly assembled. Failure to
assemble and load your sabot correctly could result in the bullet, sabot halves,
or woven wool doughnut separating and disengaging from themselves. This
could result in an air space between the components. Under such a condition,
one or more of the components may act as a barrel obstruction and firing can
result in a damaged firearm and POSSIBLE INJURY OR DEATH TO THE SHOOT-
ER OR BYSTANDERS AND DAMAGE TO PROPERTY.
To properly assemble your T/C Break-O-Way Sabot, position 2 sabot halves together
forming a complete sabot cup. Press the woven wool “doughnut” firmly on the base,
allowing the flange to protrude through the hole. Your sabot is now ready to accept a
.429" - .430" diameter .44 cal bullet. Use only bullets of these dimensions.
Use only bullets measuring .429" - .430" designed for use in .44 caliber pistols
or rifles. Using bullets of lesser diameter may cause the bullet to separate from
the sabot resulting in a barrel obstruction. Using bullets of larger diameter
could result in difficult loading, or a condition where the sabot is not seated all
the way down in the powder charge, resulting in a barrel obstruction. Either
case can result in a damaged firearm and POSSIBLE INJURY AND/OR DEATH TO
THE SHOOTER OR BYSTANDERS AND DAMAGE TO PROPERTY.
Assembled
Sabot
Woven Wool
"Doughnut"
Sabot
Halves
.429" to .430"
Bullet