Manual

48
Assembly and Loading of
T/C Mag Express
™
Sabots
T/C Mag Express Sabots come in several variations for .50 caliber muzzleloading
applications; some accept 44 caliber (.429” - .430” diameter) bullets and others accept
45 caliber (.451” - .452” diameter) bullets. In either case, insert the correct diameter
projectile into the sabot and press firmly, making sure the bullet is fully seated.
When loading T/C’s Mag Express Sabots, make sure that your gun is unprimed,
and that your Mag Express Sabot has been properly assembled. Failure to
assemble and load your sabot correctly could result in the bullet disengaging
from the sabot. This could result in an air space between the components. UN-
DER SUCH A CONDITION, ONE OR MORE OF THE COMPONENTS MAY ACT AS A
BARREL OBSTRUCTION AND FIRING COULD RESULT IN INJURY AND/OR DEATH
TO THE SHOOTER OR BYSTANDERS AND DAMAGE TO PROPERTY.
To properly assemble your T/C Mag Express Sabot, insert the projectile into the
sabot and press firmly, making sure the bullet is fully seated. Use only bullets of the cor-
rect diameter.
Use only bullets of the correct diameter that were designed for the sabots you are
using. Using bullets of lesser diameter may cause the bullet to separate from the
sabot resulting in a barrel obstruction. Using bullets of larger diameter could
result in difficult loading, or a condition where the sabot is not seated all the way
down on the powder charge, resulting in a barrel obstruction. EITHER CASE CAN
RESULT IN A DAMAGED FIREARM AND POSSIBLE INJURY AND/OR DEATH TO THE
SHOOTER OR BYST
ANDERS AND DAMAGE TO PROPERTY
.
Assembled Sabot
Mag Express
Sabot
Bullet
of the
Correct
Diameter
Seat Fully