Manual

G2 Contender Rifle sights:

The barrel has been drilled and tapped for use with standard scope mounts -

these are generally available from your Thompson/Center dealer.

Mounting a Scope on a G2 Contender

The Thompson/Center G2 Contender is factory drilled and tapped for

Thompson/Center’s mounting systems. When mounting any scope on the G2

Contender, follow the instructions which accompany the mounting system you

are using, and the instructions which accompany the scope. Those who are

unfamiliar with mounting scopes should contact a competent gunsmith for

assistance.

Make sure the G2 Contender is unloaded, with the action open before

adjusting the rear sight or mounting a scope. An accidental discharge

can cause injury and/or death to the shooter and bystanders and

damage to property.

Custom Alterations & Conversions

G2 Contender Pistols and rifles or G2 Contender Accessory Barrels which are

subjected to custom alteration or conversion other than those performed by

the Thompson/Center Custom Shop are not covered by our warranty.

Thompson/Center does not endorse or recommend any type of custom alter-

Elevation Adjustment Screw

Windage Adjustment Screw