Manual

G2 Contender trigger stop screw: A trigger stop screw is located in the trigger

guard directly behind the trigger. Extremely helpful for target shooting, this

adjustment should be set on minimum. In other words, turn the adjustment

until the trigger will not release, then gradually back off the adjustment until

the trigger just releases. An extra quarter turn affords the proper setting and

insures that the trigger will release every time.

G2 Contender

Pistol and Rifle

Assembly & Disassembly

Always make sure the chamber is empty prior to removing or install-

ing a barrel. Working on a loaded firearm could result in an acci-

dental discharge. An accidental discharge can result in injury and/or

death to the shooter or bystanders and damage to property.

The G2 Contender Pistol can be broken down into 4 major compo-

nents: 1. Pistol Grip 2. Frame Assembly 3. Barrel 4. Forend

To Disassemble the G2 Contender Pistol, do the following:

1. Keeping the G2 Contender pointed in a safe direction, open the G2

Contender pistol by pulling rearward on the trigger guard spur. (See opera-

tions section of the G2 Contender pistol).

2. Check the chamber to ensure that the G2 Contender is not loaded.

3. Close the action and with a suitable screw driver, remove the forend

screws. Then remove the forend.

Pistol