Manual

35
(as viewed from the receiver end) to lower the point of impact, and counter-clockwise, to
raise the point of impact.
To adjust the windage it is necessary to move the entire rear sight leaf left or right by
using the slotted screw head on the right side of the rear sight (as viewed from the receiv-
er end of the sight). Move the rear sight blade in the direction you want your shots to hit-
-(Example; Turn the screw clockwise - thereby moving the sight blade to the right, to move
your shots to the right and counter-clockwise to move the shots to the left).
Mounting A Scope On The
G2 Contender
™
Muzzleloader
Do not drill additional holes in the barrel as this could weaken its structure and
contribute to a rupture causing injury and/or death to the shooter or bystanders
and damage to property.
See the current T/C Catalog for scope mounting systems which can be used on your
G2 Contender. The receiver is factory drilled and tapped for these accessories.Questions
should be addressed to our Service Department, at Telephone #[phone].
Should your firearm require adjustment, repair or refinishing, we strongly recom-
mend that the firearm be returned to the factory. There is no other way to ensure that the
work will be done by a competent staff of trained technicians.
Firearms returned to the factory should be marked to the attention of the service de-
partment. A letter of instructions should be enclosed to facilitate handling. Firearms should
be uncharged, disassembled and shipped via United Parcel Service (U.P.S.).
Our Service Department will give your firearm a complete inspection and evaluate the
problem. If the work required is not covered by our “Lifetime Warranty” you will receive
a quotation which must be authorized by you. No actual work will be done without your
approval.
Windage
Adjustment Screw
Elevation 
Adjustment
Screw