Manual

Loading Sabots or Conical Bullets

with Pyrodex

or Triple Seven Pellets

If you are loading Thompson/Center Sabots, make sure that the bore has been

swabbed and that all of the oil or lube has been removed. The drier the bore, the better,

as this will improve accuracy.

Start by loading (2) 50 grain Pellets, dropping each pellet down the bore.

Insert your sabot (with bullet installed) or conical bullet into the muzzle using your

fingers. Push the projectile into the barrel as far as you can, until it stops. This portion of

the muzzle is the recessed portion of T/C’s QLA Muzzle System. Your projectile is now per-

fectly aligned to the center axis of the bore, surrounded by 360

of barrel.

Photo A

Projectile inserted in the

Quick Load Accurizor (QLA) Muzzle,

perfectly aligned.

Choking up on your ramrod, or with a short starter, drive the projectile into the

bore. There will be a minimal amount of resistance to overcome initially. (See Photo B)

Photo B

Drive the projectile into the barrel with

firm pressure or a short rap.