Manual

Encore

Trigger

Always make sure the chamber of your Encore is unloaded prior to

adjusting the trigger. Working on a loaded pistol could result in an acci-

dental discharge which can result in injury and/or death to the shooter

or bystanders and damage to property.

Encore triggers are factory set. No adjustment should be required or

attempted. Alteration of the trigger spring or use of a non-factory spring can

create a dangerous trigger pull.

Too light a trigger pull

can cause premature firing which may cause injury and/or death to the

shooter or bystanders and damage to property

. Altered parts may also

produce an unsafe trigger pull. In no event should parts be filed, honed,

ground or replaced by non-factory parts.

Encore trigger stop screw: A trigger stop screw is located in the trigger

guard directly behind the trigger. Extremely helpful for target shooting, this

adjustment should be set on minimum. In other words, turn the adjustment

until the trigger will not release, then gradually back off the adjustment until

the trigger just releases. An extra quarter turn affords the proper setting and

insures that the trigger will release every time.

Encore

Assembly & Disassembly

Always make sure the chamber is empty prior to removing or installing

a barrel. Working on a loaded pistol could result in an accidental dis-

charge. An accidental discharge can result in injury and/or death to the

shooter or bystanders and damage to property.

The Encore pistol can be broken down into 4 major components:

1. Pistol Grip 2. Frame Assembly 3. Barrel 4. Forend

To Disassemble the Encore Pistol, do the following: