Manual

40
TRIGGER ADJUSTMENT
MAKE SURE THAT THE FIREARM YOU ARE WORK-
ING WITH IS UNCHARGED AND UNPRIMED PRIOR
T
O MAKING ANY TRIGGER ADJUSTMENTS. FAILURE
TO HEED THIS WARNING COULD RESULT IN ACCIDENTAL
DISCHARGE WHICH MAY CAUSE INJURY AND/OR DEATH
TO THE SHOOTER OR BYSTANDERS AND DAMAGE TO
PROPERTY.
Adjustments can only be made to
the Trigger Stop Screw shown in this
diagram.A .050" hex wrench is
required to make adjustments.
The Trigger Stop Screw is used to
adjust “over-travel”. Over-travel is
the amount of rearward trigger movement after the trigger releas-
es the hammer.
ENCORE TRIGGERS ARE FACTORY SET TO AN OPTIMAL
PULL. PHYSICAL ALTERATION OF THE TRIGGER, OR AD-
JUSTMENTS OTHER THAN THOSE DESCRIBED ABOVE
WITH TRIGGER STOP SCREW MAY LEAD TO A SITUATION
WHERE A DANGEROUSLY LIGHT TRIGGER PULL RESULTS. A
TRIGGER PULL THAT IS TOO LIGHT CAN CAUSE PREMATURE
FIRING WHICH MAY LEAD TO INJURY AND/OR DEATH TO THE
SHOOTER OR BYSTANDERS AND DAMAGE TO PROPERTY.
Encore Trigger Adjustment
T
rigger Stop Screw