Operating instructions

17
Empty the dirty water tank after you have used up all the
water and completely fill the cleansing agent tank from the
fresh water tank to prevent the appliance being switched off
automatically.
Should you not observe the above-mentioned instructions the
float will automatically switch off the appliance as soon as the
dirty water tank is full. (The motor will be clearly heard to be
running at a higher speed.
Switch off appliance, disconnect the mains plug and empty the
dirty water tank.
Hard floor cleaning
Push the hard floor adapter into the carpet spray nozzle.
By using this system you can clean and dry your hard floor coverings
at one and the same time.
See carpet cleaning for procedure.
We recommend THOMAS ProFloor concentrated cleaning
agent for hard floor cleaning.
Upholstery cleaning
Use the upholstery spray nozzle to clean upholstered furniture, car
seats, etc. Push this nozzle on the handle together with the shut-off
valve (24). Fasten the short spraying hose to the shut-off valve and
nozzle.
When cleaning upholstery make sure that not too much liquid is
applied because you will have to take a longer drying time into con-
sideration depending on the sub-structure.
See carpet cleaning for procedure.
We recommend THOMAS ProTex concentrated cleaning
agent for upholstery cleaning.
Window cleaning
Push the window nozzle adapter on the carpet spray nozzle. You can
clean your windows and glass surfaces with this system and dry the
surfaces at the same time.
See carpet cleaning for procedure.
To suck up liquids
You can suck up spilled, non-hazardous water-based liquids
(for example water, coffee, etc.) with the THOMAS TWIN tt
AQUAFILTER.
Select a suitable nozzle and fit it to the respective suction tube or
handle.
Cleaning and maintenance
Only service and clean the appliance when it is switched off
and the mains power plug has been connected.
After wash cleaning / sucking up liquid
Please use a moist soft cloth to clean the appliance housing.
Do not use any aggressive cleaning agents or solvents.
Remove fresh water tank empty.
Empty dirty water tank.
Clean anti-swash insert, dirty water tank and wet filter using
clear, possibly warm water.
Check motor protection filter for contamination and clean
under flowing water and renew, if necessary.
Keep float (13b) in the dirty water tank clean and fully functional
at all times. This float interrupts the suction operation when the
dirty water tank is full.
Dry up spray water in suction chamber with soft cloth.
Remove contamination on the intake connector and on the
inside of the housing cover.
The housing cover can be taken off the appliance for easier
cleaning.
To do this open the cover and swing it down vertically. Press
the cover forwards until it slides out of the hinge. Afterwards
swing the cover upwards and out of the way.
Insert in the housing cover vertically to fasten and close it. The
cover automatically clips into the hinge.
Fill the fresh water tank with clear water to service
the pump and valves and make the appliance
ready for operation.
Put the spraying system into operation (operate
the lever on the shut-off valve) over a wash basin,
for example.
The appliance and accessory parts are to be thoroughly dried
after being used for cleaning.
Press the shut-off valve lever to make the system completely
pressureless.
After vacuuming
1. AQUA filter system
Open housing cover by lifting up the cover catch.
Remove dirty water tank.
Pull the AQUA filter (12) out of the dirty water tank by means of the
grip and pour the dirty water away (for example in the toilet).
Remove foam filter (12a). To do this pull the AQUA filter frame slightly
upwards and then fold it over to the side out of the way.
Now thoroughly rinse the AQUA filter, foam filter, wet
filter and the dirty water tank with clear water. Do not
use any cleaning agents.
It is essential to ensure that the parts are dry before
being refitted.