Operating instructions

15
General instructions
To connect up suction hose
- Insert the suction hose connection piece in the appliance connector
and turn backwards until it locks.
- Push spraying agent hose in the fast coupling; to do this open
pump cover by pressing down the bottom section.
- Insert shut-off valve in the holder on the suction tube.
To remove suction hose
- Press the button on the connection piece. Turn the connection
piece a quarter of a turn to the side and draw out.
- Release spraying agent hose; to do this press the fast coupling
button.
Parking position
- Hang the suction tube complete with nozzle and hose in the
suction tube holder on the back of the appliance.
- Should the appliance be stored in the upright position hang the
suction tube on the bottom of the appliance.
Electronic suction power control
Switch the appliance on/off by gently pressing the ONE-TOUCH
key.
- Press down the key briefly:
Appliance switches on; rating 850 Watt (ECO stage);
green indicator lamp comes on
- Hold-down key:
Infinitely variable electronic suction power control
between 650 and 1600 Watt
Signal lamp green: MIN. 650 Watt to 1125 Watt;
Signal lamp yellow: 1125 Watt to MAX. 1600 Watt.
The signal lamp goes out briefly when reaching the minimum or
maximum capacity.
- Press key briefly again:
Appliance turns off.
The AQUAFILTER system offers particularly good filtration at
a rating between 850 W (ECO stage) and MAX 1600 W.
Consequently only use the appliance at MIN rating (650 Watt)
for a short time (when vacuuming curtains, for example).
Mechanical suction power control
The suction power can also be adjusted by means of the mechanical
suction power controller (auxiliary air slide).
Auxiliary air slide closed = full suction power
Auxiliary air slide open = reduced suction power.
The auxiliary air slide must always be closed when using the
electronic suction power control system.
Accessory storage
The fresh water tank can be used for accessories when using the
cleaner for dry cleaning
Dust vacuuming
Information for use
● Do not use the TWIN tt AQUAFILTER for dry vacuuming
if the AQUAFILTER system has not been appropriately
fitted according to the operating instructions. This
could cause damage to the appliance.
● Do not suck up any liquids when dry vacuuming.
● Do not suck up any large quantity of fine dust, for
example, chocolate powder, flour, etc.
To make the AQUA filter ready for use
Your TWIN tt AQUAFILTER is set ready for dry vacuuming at the
works.
Open appliance cover by lifting up the cover catch.
Draw out the AQUA filter from the dirty water tank by means
of the grip. Fill up the dirty water tank with 1 litre of clean
water.
Insert the complete AQUA filter up to the stop behind the two
guide ribs of the dirty water tank.
At the same time make sure that the wet filter is fitted and the
circumventing AQUA filter seal is tight up against the inside of
the dirty water tank.
Connect up suction hose and fit telescopic suction tube. Connect the
required accessory.
To achieve optimal filtration we recommend rinsing out the
AQUA filter quickly with clear water after approx. 40-60
minutes continuous operation or when a large number of
drops of water can be seen on the underside of the cover.
You should also change the water in the dirty water tank.
Should crevice nozzle or upholstery nozzle be fitted to the tube
bend, use the nozzle adapter which can be fastened to the
shut-off valve (24).
Insert nozzle adapter in either the crevice nozzle or upholstery
nozzle before fastening the shut-off valve to the adapter.
The AQUAFILTER system is to be emptied and cleaned
every time the appliance is used for hygienic reasons.
Dirty water and moist parts propagate the growth
of bacteria and fungi (see cleaning and maintenance
instructions).