Installation Manual

COPPER COLOR-KEYED
®
LONG BARREL LUGS
For 600V Applications
TA01025 U Page 1 of 2
GENERAL INFORMATION:
• Made of high conductivity copper, electro-tin plated.
• Listed for copper code cable.
• Additional listings and certications on ne strand-
ing classes: G,H,I,K and M.
• Long barrel type - 600V applications for one bolt,
two bolt lugs.
• Color coded to assist in the matching of installing
die and connector.
INSTALLTION INSTRUCTIONS:
1. Strip the insulation from cable to the length shown
in table (on reverse side). Be careful not to nick
cable strands.
2. Cable end should be clean: wire brush or clean
with emery cloth if necessary. Insert cable into
connector until it stops. The insertion length must
approximate the stripped length of cable.
3. Insert connector in die and compress between
the markings beginning near the tongue of the
connector. Table on reverse side shows installing
die and the number of compressions required for
each die connector combination.
CAUTION
Using improper installing die may result in a
defective connection.
4. After crimping, remove all sharp edges, ash or
burrs.
5. Insulating methods shown in table on reverse side.
WARNING
DO NOT CRIMP ON ENERGIZED WIRES.
WARRANTY: Thomas & Betts sells this product with the understanding that the user will perform all necessary tests to determine the suitability
of this product for the user’s intended application. Thomas & Betts warrants that this product will be free from defects in materials and
workmanship for a period of two (2) years following the date of purchase. Upon prompt notication of any warranted defect, Thomas & Betts
will, at its option, repair or replace the defective product or refund the purchase price. Proof of purchase is required. Misuse or unauthorized
modication of the product voids all warranties.
Limitations and Exclusions: THE ABOVE WARRANTY IS THE SOLE WARRANTY CONCERNING THIS PRODUCT, AND IS IN LIEU OF ALL
OTHER WARRANTIES EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE, WHICH ARE SPECIFICALLY DISCLAIMED. LIABILITY FOR BREACH OF THE ABOVE
WARRANTY IS LIMITED TO COST OF REPAIR OR REPLACEMENT OF THE PRODUCT, AND UNDER NO CIRCUMSTANCES WILL
THOMAS & BETTS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
© 2012 Thomas & Betts Corporation. All Rights Reserved.
Thomas & Betts Corporation
Memphis, Tennessee
In Canada, Thomas & Betts Ltd., Iberville, P.Q.
www.tnb.com