Assembly instructions

2.2 Inserting the motor
Hang the drive belt (8) on the motor unit (9) as shown.
The drive belt hangs loosely on the motor unit and is only tensioned when
the resonators are installed.
Hook in the motor unit (9) with the drive belt on the control unit (10) of the narrow
upper part (3) as shown.
Connect the motor unit cable (11) to the control unit connector (12).
2.3 Inserting bars and hanging in resonators
Place the pre-assembled unit consisting of bar 2 (13) and bar 3 (14) in the mounts
provided on the upper parts (1, 3).
When inserting, make sure that the numbers on the bars and mounts of the
upper parts match.
)
*
$
+
-
*
,
/
.
ö
$
Setup
THV 3.0
7
Vibraphone