Assembly instructions

2 Setup
2.1 Assembling the frame
Place the wide upper part (1) on the wide lower part with the long guide pin (2) and
tighten the wing screws.
Place the narrow upper part (3) on the narrow lower part with the short guide pin (4)
and tighten the wing screws.
Pull the cotter pin (5) out of the slot for the centre rod (6) of the wide and narrow
base.
Insert the centre rod (6) into the slot of the wide base (2). Pay attention to the mark‐
ings (red dots) on the centre rod and the mount.
Attach the centre post brace to the lower cross brace of the wide base (2) as shown
and reinstall the cotter pin.
Proceed in the same way for the narrow lower part (4). Note that there are no mark‐
ings (red dots) here.
Loosen the pedal rod thumbscrew (7) and insert the pedal rod into the slot in the
wide base (2) as shown.
Push the right end of the pedal rod (7) toward the wide base (2) until you feel spring
resistance, and insert the pedal rod (7) into the slot of the narrow base (4). Tighten
the wing screw.
ö
$
%
#
'
&
&
(
'
#
(
Setup
6
THV 3.0
Vibraphone