Assembly instructions

Hook the pedal pull rod (23) into the mount on the pedal rod (7) as shown.
2.5 Installing sound plates
Place the semitone sound plates (24) on bars 1 (19) and 2 (13). Thread the cord of the
sound plates around the end pegs (26) and install each sound plate between the
pegs of the bars.
Then place the whole-tone sound plates (25) on bars 3 (14) and 4 (20). Thread the
cord of the sound plates around the end pegs (26) and install each sound plate
between the pegs of the bars.
Connect the tension springs together at the end of the cord.
Pay attention to the dierent cord guide of the hook peg (27) and the saddle peg
(28).
To better put the cord under the hook, step on the pedal.
(
8
9
:
;
$
1
0
;
;
;
:
9
<
=
Setup
10
THV 3.0
Vibraphone