Combo 88 Desk Assembly Manual
For reasons of safety and stability, parts number 7, 12 and 15 (3 pieces) are assembled during transport. Before you start building your Combo desk88 , turn part #7 with its underside upwards and lay it on the ground. You will see 4 screws (Type A) which hold together the three parts. Remove them and disassemble the parts carefully (keep the screws for later). You are now ready to start building your Combo 88 studio desk. 12 11 10 12 9 8 15 7 15 15 2.1 2 7 6 3 4 1.1 14.
STEP 2 Push wooden dowels Type W in the appropriate holes Step 1 A 5 heights 1/2 1st 57 mm 2nd 77 mm 3rd 97 mm 4th 117 mm 5th 137 mm B 3 1/2 Use plastic insert type I C Use screws Type S D Use screws Type S STEP 3 3 1/2 2 1/2 1 Type F
STEP 4 Use screws Type E STEP 5 3 4 2 1 STEP 6 4 Use hex wrench to screw Tighten the screw until it is even with the particle board Use screws caps 2 1
STEP 7 STEP 9 6 3 2 3 1 2 5 1 STEP 8 Use screws Type E STEP 10 Use screws Type E 2 1
STEP 11 STEP 12 Use screws Type E 7 7 2 1
STEP 13 Use screws Type A (x8) STEP 14 11 10 9 8 11 STEP 15 10 9 8 7
STEP 17 Use screws Type A M6x30mm (x4) STEP 16 Use screws Type D m6x100mm (x4) 12
STEP 20 STEP 18 2.1 13 1.1 STEP 19 STEP 21 2.1 14.2 1.1 14.
STEP 22 STEP 24 Use screws Type E 14.2 13 14 14.
STEP 26 Use screws Type A (x4) STEP 27 Fix Rack rail with screws Type RS
If you don't need the rack units don't fix the rack rails and use the pieces number 15 to close the holes PACKING LIST: x49 Type 35 W x29 E Type x16 Type A x4 Type D mm Wooden dowels x30 Type I Euro Screws x6 Type m6x30 mm R x12 Type m6x100 mm Rs x36 Type Ru 15 15 Rack rail Plastic insert x6 Type S x4 Type Rack rail screws F x1 Type H Rack units screws x2 Type 15 3x20 mm TOOLS: Plastic foot Hex wrench Sliders SL
