User's Guide

NCC warning:
The low-power RF motor that has passed the type certification is not approved, and the
company, company or user shall not change the frequency without authorization
Rate, increase power or change the original design features and functions.
The use of low-power RF motors must not affect flight safety and interfere with legal
communications; when interference is found, it should be immediately
Stop using it and improve it to no interference before continuing to use it. The legal
communication in the preceding paragraph refers to the radio communication operating in
accordance with the provisions of the Telecommunication Law
letter. Low-power RF motors must tolerate interference from legal communications or radio
wave radiating motor equipment for industrial, scientific, and medical use.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.