User's Manual

press and hold the reset button on the left side of the sensor for 5 seconds and release the hold;
The blinking cloud icon on the the LED screen indicates the sensor is in pairing mode.
③
Open the SmartThings App, tap “+” on the upper right corner to
”
Add device” and then tap
“Scan” to “Scan for nearby devices”.
④
The Smart Button will be paired with the SmartThings hub in a few seconds.
⑤
Create routines to control connected devices.
Pairing with Hubitat
Website: http://find.hubitat.com/
Pairing Steps:
①
Remove the plastic stand on the back of the Temp & Humidity Sensor carefully, open the
battery cover on the back, remove the plastic insulation sheet and the sensor is powered on; Or
press and hold the reset button on the left side of the sensor for 5 seconds and release the hold;
The blinking cloud icon on the the LED screen indicates the sensor is in pairing mode.
②
Visit your Hubitat Elevation hub device page from your web browser, select the Devices menu
item from the sidebar, then select Discover Devices in the upper right.