Operation Manual
8
1-5-3. Connecting to power
①
Connect the power cable to DC-IN socket of
the device.
②
Plug the charger adapter end of the power
cable into a 12V DC vehicle power socket.
③ Arrange the wire by using the adhesive cable
holder as shown below.
④
Adjust the camera so that the dash cam is facing
forwarding and level with the vehicle and the road.
After installation, turn on the dash cam and use the live view
on the LCD screen to adjust the camera angle.
TIP
Preventing Vehicle Battery Discharge
■ Depending on the car make and model, the power from the vehicle can be supplied even with
the ignition turned off. In this case, the dash cam stays on as continuous mode and does not
enter parking surveillance mode which will result in vehicle battery discharge.
■ Some vehicles with multiple power sockets might be equipped with at least 1 outlet that does
not shut off the power with the ignition. So, test each power outlet to ensure you connect to an
outlet that shut off with vehicle engine.
For more information on the power cable routing instruction, please visit Thinkware homepage
(http://thinkwaredashcam.com)
Hide the extra wires by placing the wires in the space be-
tween the ceiling of vehicle and the top of the windshield.
Recommended location for ad-
hesive wires clips are illustrated
in the diagram