User Manual

29
4. Using Advanced Driver Assistance Systems
(ADAS)
ADASusesthesafetycameraalertsystem,alanedeparturewarningsystem(LDWS),aforwardcollision
warning system (FCWS), an urban forward collision warning system (uFCWS), and a front vehicle departure
warning (FVDW).
To use ADAS, you must install the optional external GPS module or the THINKWARE Connected Dongle (to
provide vehicle location and speed related information). For more information, refer to "2.3 Installing the
externalGPSmodule(optional)"or"2.4InstallingtheTHINKWAREConnectedDongle(optional)".
Use the authentic THINKWARE GPS module and Connected dongle. If you use another manufacturer's GPS
module or Connected dongle, the product may be damaged or electrical fire or electrocution may result due
to the voltage difference.
All ADAS Settings are configurable in the dashcam settings. These features will only be activated when the
external GPS module or the THINKWARE Connected Dongle is installed.
Identifying the vehicle type
OntheLiveviewscreen,taptheHomebutton( )
>
Settings
>
Road Safety Settings, and then tap the
button next to Vehicle type under ADAS Features to select a vehicle type among Sedan / SUV / Truck (Bus).
Setting the ADAS settings
To enhance the ADAS accuracy, follow the instructions to calibrate the ADAS settings screen.
1
On the Live view screen, tap the Home button ( )
>
Settings
>
Road Safety Settings, and then tap the
View button next to ADAS settings under ADAS Features.
2
Adjust the product to align the blue line displayed on
the ADAS settings screen with the center of the hood
and the green line just above the hood.
After positioning the product, drive at 30 km/h for
more than 1 minute to finish the alignment.
When you align the ADAS settings screen, adjust the product position within 7 cm of the default installation
location (where the camera lens is located at the center of the front windshield).