User's Manual
Table Of Contents
- Safety information
- 1. Product overview
- 2. Installing the product
- 3. Using recording features
- 4. Using the mobile viewer
- 5. Using the PC viewer
- 6. Settings
- 6.1 Managing the memory card
- 6.2 Setting the camera
- 6.3 Setting recording features
- 6.3.1 Setting the continuous impact detection sensitivity
- 6.3.2 Setting parking mode
- 6.3.3 Setting the impact sensitivity in parking mode
- 6.3.4 Setting the motion detection sensitivity
- 6.3.5 Setting the record timer feature
- 6.3.6 Setting the battery protection feature
- 6.3.7 Setting the battery cutoff voltage feature
- 6.3.8 Setting the battery protection feature for wintertime
- 6.4 Setting road safety features
- 6.5 Configuring the system settings
- 7. Accessing the product information
- 8. Upgrading the firmware
- 9. Troubleshooting
- 10. Specifications
Settings
39
6.4 Setting road safety features
You can activate or deactivate a safety camera alert system.
6.4.1 Setting the safety cameras
When the vehicle approaches or passes the speed limit zone, the safety camera alert system will collect
GPS signals and safety camera data. Refer to the following instructions to enable or disable this feature.
1
From the mobile viewer, tap Dash Cam Settings
>
Road Safety Settings.
2
From Safety Cameras, select Enabled or Disabled. The new setting is applied automatically.
6.4.2 Setting the mobile zone alert
Follow the instructions to turn on or off the mobile zone alert.
1
From the mobile viewer, tap Dash Cam Settings
>
Road Safety Settings.
2
From Mobile Zone Alert, select Enabled or Disabled. The new setting is applied automatically.
6.5 Configuring the system settings
This menu allows you to configure the hardware settings that are globally applied to the system during
operation, such as the display language and screen brightness.
6.5.1 Setting the display language
Select a language to display on the screen. Follow the instructions to select a language.
1
From the mobile viewer, tap Dash Cam Settings
>
System Settings.
2
From Language, select the desired language. The new setting is applied automatically.