User's Manual
Table Of Contents
- Safety information
- 1. Product overview
- 2. Installing the product
- 3. Using recording features
- 4. Using the mobile viewer
- 5. Using the PC viewer
- 6. Settings
- 6.1 Managing the memory card
- 6.2 Setting the camera
- 6.3 Setting recording features
- 6.3.1 Setting the continuous impact detection sensitivity
- 6.3.2 Setting parking mode
- 6.3.3 Setting the impact sensitivity in parking mode
- 6.3.4 Setting the motion detection sensitivity
- 6.3.5 Setting the record timer feature
- 6.3.6 Setting the battery protection feature
- 6.3.7 Setting the battery cutoff voltage feature
- 6.3.8 Setting the battery protection feature for wintertime
- 6.4 Setting road safety features
- 6.5 Configuring the system settings
- 7. Accessing the product information
- 8. Upgrading the firmware
- 9. Troubleshooting
- 10. Specifications
Installing the product
17
2.2.2 Securing the rear camera
Refer to the following instructions to secure the product to the installation location.
1
After determining the installation location, wipe the installation surface of the windshield with a dry
cloth.
Check the installation location before you secure the rear camera to the rear windshield. After
securing the rear camera to the windshield, it is hard to remove the camera or change the installation
location due to the strong adhesive.
2
2
1
Remove the protective film from the adhesive mount
and camera lens.
Attach the product with the THINKWARE logo facing
indoors and press the adhesive tape firmly to secure
the camera.
If the product is fixed in reverse, the rear view
will be recorded upside down.
Adjust the camera's vertical angle.
3
THINKWARE
4
THINKWARE