User's Manual
Table Of Contents
- Safety information
- 1. Product overview
- 2. Installing the product
- 3. Using recording features
- 4. Using the mobile viewer
- 5. Using the PC viewer
- 6. Settings
- 6.1 Managing the memory card
- 6.2 Setting the camera
- 6.3 Setting recording features
- 6.3.1 Setting the continuous impact detection sensitivity
- 6.3.2 Setting parking mode
- 6.3.3 Setting the impact sensitivity in parking mode
- 6.3.4 Setting the motion detection sensitivity
- 6.3.5 Setting the record timer feature
- 6.3.6 Setting the battery protection feature
- 6.3.7 Setting the battery cutoff voltage feature
- 6.3.8 Setting the battery protection feature for wintertime
- 6.4 Setting road safety features
- 6.5 Configuring the system settings
- 7. Accessing the product information
- 8. Upgrading the firmware
- 9. Troubleshooting
- 10. Specifications
Installing the product
16
2.2 Installing the rear camera (optional)
Refer to the following instructions to properly install the rear camera.
2.2.1 Selecting an installation location
Select a location on the rear windshield where there
is no defrost grid wire and the camera can record
the entire rear view.
•For vehicles with a sunshade attached to the rear windshield, you must select a location where using the
sunshade will not interfere with camera operation.
•The adhesive part of the rear camera should not touch the defrost grid.