User's Manual
Table Of Contents
- Safety information
- 1. Product overview
- 2. Installing the product
- 3. Using recording features
- 4. Using the mobile viewer
- 5. Using the PC viewer
- 6. Settings
- 6.1 Managing the memory card
- 6.2 Setting the camera
- 6.3 Setting recording features
- 6.3.1 Setting the continuous impact detection sensitivity
- 6.3.2 Setting parking mode
- 6.3.3 Setting the impact sensitivity in parking mode
- 6.3.4 Setting the motion detection sensitivity
- 6.3.5 Setting the record timer feature
- 6.3.6 Setting the battery protection feature
- 6.3.7 Setting the battery cutoff voltage feature
- 6.3.8 Setting the battery protection feature for wintertime
- 6.4 Setting road safety features
- 6.5 Configuring the system settings
- 7. Accessing the product information
- 8. Upgrading the firmware
- 9. Troubleshooting
- 10. Specifications
Installing the product
14
3
1
2
Remove the protective film from the adhesive mount,
and then press the mount to the installation location.
4
1
2
Remove the product from the mount and push the
mount against the windshield to ensure that the
mount is firmly fixed.
5
Align the product to the mount, and then slide it into
the locking position until you hear a click.
•The product may fall and be damaged during vehicle operation if it is not firmly fixed to the mount.
•If you need to remove the mount from the windshield to alter the installation location, be careful not
to damage the windshield’s film coat.
6
Set the vertical angle of the camera appropriately
and tighten the screw of the mount firmly by using a
flat-head screwdriver or a coin.
To confirm the camera angle, record a video after installation and check the video using the mobile
viewer or the PC viewer. If necessary, adjust the camera angle again.
For more information about the mobile viewer or the PC viewer, refer to "4. Using the mobile viewer" on
page 22 or "5. Using the PC viewer" on page 26.