Operation Manual

8
After installation, run the dash cam to record videos and
check the videos using Thinkware Dash Cam Viewer to
verify camera position. Adjust the camera angle if neces-
sary.
TIP
1-5-3. Connecting to power
Connect the power cable to DC-IN socket of
the device.
Plug the car charger adapter end of the power
cable into a 12V DC vehicle power socket.
Arrange the wire by using the adhesive cable
holders as shown below.
Adjust the camera so that the dash cam is facing
forward and is level with the road.
Preventing Vehicle Battery Discharge
Depending on the make and model of your car, the power may be supplied to the dash cam
even with the ignition turned off. This may result in vehicle battery discharge.
Some vehicles with multiple power sockets might be equipped with at least 1 outlet that does
not shut off the power with the ignition. Test each power outlet to ensure you connect to an out-
let that shuts off with vehicle ignition.
For more information on the power cable routing instruction, please visit Thinkware homepage.
(www.thinkware.com)
Hide the power cable by placing (tucking) it in the space
between the vehicle ceiling and headliner at the top of the
windshield
Recommended locations for
attaching adhesive wire clips
to arrange the power cable are
illustrated in the diagram