Users Manual

Installing the product
13
3
1
2
➊➊
➋➋
Remove the protective film from the adhesive mount,
and then press the mount to the installation location.
4
3
2
1
➊➊
➌➌
➋➋
Pull the slide lock to the right and pull up the cradle
to remove it from the product. Then push the cradle
against the windshield to ensure that it is firmly
fixed.
5
Align the product to the cradle, and then slide it into
the locking position until you hear a click.
• The product may fall and be damaged during
vehicle operation if it is not firmly fixed to the
cradle.
• If you need to remove the cradle from the
windshield to alter the installation location, be
careful not to damage the windshield’s film coat.
6
Set the vertical angle of the camera appropriately.
• You can also set the vertical angle of the camera by using a flat-head screwdriver or a coin.
• To confirm the camera angle, record a video after installation and check the video using the mobile
viewer or the PC viewer. If necessary, adjust the camera angle again. For more information about the
mobile viewer or the PC viewer, refer to "4. Using the mobile viewer" on page 21 or "5. Using the PC
viewer" on page 22.