User's Manual Part 1

16
2-8-1. Incident Recording
 When the dash cam detects impact while parked, it will
immediately store the 10 seconds prior and after the
impact.
The 20-second impact recording is saved on the MicroSD
card under the "evt_rec" folder.
2-8-2. Motion Detection Recording
The dash cam and the optional rear view camera are both equipped with motion detectors which are used
to detect motion that initiates video recording while the vehicle is parked.
 When the dash cam detects motion while parked, it will immediately store the previous 10 seconds prior to
the activation of motion detection start recording video for the next 10 seconds.
- The 20-second motion detection recording is then saved on the MicroSD card under the folder named
"motion_rec".
2-8-3. Time Lapse Recording
Time Lapse Recording captures at one frame per second during parking. This allows the dash cam to reduce
video le size to allow more footage to be stored on the MicroSD card.
 Impact Detection is enabled for Time Lapse Recording. When the dash cam detects impact while parked, it
will store the 3 minutes and after a parking incident for a total of 6 minutes.
- The recording is then saved on the MicroSD card under the folder named "motion_timelapse_rec".
 Motion Detection Recording and Time Lapse Recording cannot be used at the same time.
┗ To enabled Time Lapse, go to "Thinkware Dash Cam Mobile Viewer > Settings > Dash Cam Settings >
Record Settings > Parking Mode > Time Lapse" (For more information on the Time Laps, refer to Using
Thinkware Mobie viwer on page 20)"
 If Motion Detection Recording is enabled, all existing Time Lapse Recordings on the MicroSD card will be
erased.
2-8. Recording Videos While Parked (Optional Accessory)
This feature is available only when the dash cam has been hardwired direct to the vehicle battery.
Separate purchase is required for the hardwiring cable accessory and installation is required.