User Manual
Table Of Contents
- Product introduction
- Product composition
- Trainer Installation
- Caveat
- Special remind
- Představení produktu
- Složení výrobku
- Instalace trenažéru
- Upozornění
- Speciální připomínka
- Predstavenie produktu
- Zloženie výrobku
- Inštalácia trenažéra
- Oznámenie
- Špeciálna pripomienka
- A termék bevezetése
- A termék összetétele
- Edző telepítése
- Caveat
- Különleges emlékeztető
- Produkt-Einführung
- Produktzusammensetzung
- Trainer-Installation
- Caveat
- Besonders erinnern
5
Trainer Installation
1. Place the trainer on a level surface, install two horizontal feet.
2. Note that the length of the two feet is not the same, left and right direction can not be
installed in the opposite direction. Refer to the top view below.
3. There is a freehub on the cycling trainer, which supports the standard shimano and
sram 8-11 speed cassettes.
4. Install your bike on the trainer, just like install the rear wheel on the bike.
5. The installation method of Q.R. /Thru Axle converters is shown below.
6. Make sure your bike is LOCKED to the trainer, in case it comes loose and causes harm.
Quick release
Thru axle (Optional)
Make sure your bike is LOCKED.
(Top View)
Suitable for 130mm spacing
Suitable for 135mm spacing
Suitable for 142mm spacing
Suitable for 148mm spacing