User Guide
Table Of Contents
- Note Regarding RF Exposure.
- FCC Notice and Cautions
- Compliance FCC Part 90
- Acceptable Frequencies
- Migrating from Thinkify HSP2_0 to HSP3_0 firmware
- Ethernet Communication between HOST and THINKIFY HSP3.0
- Output and Status Messaging in the Thinkify HSP3.0 system
- IO and Timing control in the Thinkify HSP3.0 System
- System Type Functions and control in the Thinkify HSP3.0 system
- Using the LOCK function in Thinkify HSP3.0
- Controlling the programming list database in the Thinkify HSP 3.0 system
Programmer3.0 Specific TR65 Commands
Any Normal TR65 command may also be sent (radio control etc)
Send command with no parameters to GET the current value
HC<2 ASCIIHEX> -- CORRECT Minimum loop time control - units are
milliseconds
HH<2 ASCIIHEX> -- HOLDOFF inhibit Trigger time control - units are
milliseconds
HI<ACTION RETRY COUNT (1 ASCIIHEX)><OPEN RETRY COUNT
(1 nibble)> -- ITERATE Controls looping retry paramters
HL<OFF> -- LOCK Inhibit LOCK command in ENCODE loop
HL<LOCK PAYLOAD (5 ASCIIHEX)> -- LOCK Set the LOCK command
payload
HP<2 ASCIIHEX> -- PAUSE Delay after Trigger time control - units are
milliseconds
HQ<1 ASCIIHEX> -- QUIET Delay after OPEN - units are milliseconds
HT<OFF or R or F> -- TRIGGER Control TRIGGER INPUT - off or edge
type RISING FALLING
HW<1 ASCIIHEX> -- WAIT Override GEN2 ASYNC WAIT - units are
milliseconds
Copyright 2014 Thinkify LLC. All Rights Reserved.
Thinkify, LLC, 18450 Technology Drive, Suite E1, Morgan Hill, Ca. 95037, www.thinkifyit.com 408-782-7111