User Guide
Table Of Contents
- Note Regarding RF Exposure.
- FCC Notice and Cautions
- Compliance FCC Part 90
- Acceptable Frequencies
- Migrating from Thinkify HSP2_0 to HSP3_0 firmware
- Ethernet Communication between HOST and THINKIFY HSP3.0
- Output and Status Messaging in the Thinkify HSP3.0 system
- IO and Timing control in the Thinkify HSP3.0 System
- System Type Functions and control in the Thinkify HSP3.0 system
- Using the LOCK function in Thinkify HSP3.0
- Controlling the programming list database in the Thinkify HSP 3.0 system
The STATUS message -
As the set of operations performed in response to a trigger is concluded, a status message
is sent indicating the success/failure of all operations performed during the interaction
with this tag. This is similar to the HSPDONE message in the 2.0 system, but since a
different set of operations is now available to be performed the syntax of this response is
changed somewhat. It is also modified in an attempt to be a more informative.
A separate document will describe the format and status codes used in this message.
System Commands -
The DISENAGE and ENGAGE commands are used to enable the acceptance of triggers
by the system. The behavior of the programming database during these commands is
controlled by the AUTOCLEAR setting.
Two further commands are provided - one to do a firmware update to the attached TR65,
and one to easily modify the STARTUP MACRO settings in a TR65 to facilitate system
setup.
A separate document will describe details of these.
List of supported commands as of version 3.0.4 5-25-2018
Programmer3.0 PI Internal Commands
QUIT - Exit the program
SYSTEMTYPE(= TYPE) - either GET the current setting of the system
type, or set it to VER,ENC,or STA
GETVERSIONS - PI and TR65 firmware version
GETBUFFERCOUNT - Current number of PROG DATA STRUCT loaded
READBUFFER - Display all PROG DATA STRUCT loaded
RESETBUFFER - Clear PROG DATA STRUCT buffer
WRITEITEM=<DATA LIST> - enter 1 item into PROG DATA STRUCT
buffer
GENERATE=<DATA LIST>,NUM(count) - create arbitrary number of
items in PROG DATA STRUCT buffer
AUTOCLEAR=<ON or OFF> - control clearing of PROG DATA STRUCT
buffer on ENGAGE
ENGAGE - START the trigger acceptance system
DISENGAGE - STOP the trigger acceptance system
TR65LOADER=<filename> - updates the firmware in the attached TR65
TR65MACROLOAD - loads the text file in the HSP_3_0 folder named
TR65MacroList.txt as a STARTUP MACRO into the TR65
Copyright 2014 Thinkify LLC. All Rights Reserved.
Thinkify, LLC, 18450 Technology Drive, Suite E1, Morgan Hill, Ca. 95037, www.thinkifyit.com 408-782-7111