User Guide
Table Of Contents
- Note Regarding RF Exposure.
- FCC Notice and Cautions
- Compliance FCC Part 90
- Acceptable Frequencies
- Migrating from Thinkify HSP2_0 to HSP3_0 firmware
- Ethernet Communication between HOST and THINKIFY HSP3.0
- Output and Status Messaging in the Thinkify HSP3.0 system
- IO and Timing control in the Thinkify HSP3.0 System
- System Type Functions and control in the Thinkify HSP3.0 system
- Using the LOCK function in Thinkify HSP3.0
- Controlling the programming list database in the Thinkify HSP 3.0 system
Note Regarding RF Exposure.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance of
20cm between the radiator (antenna) and your body. This transmitter must not be co-located
or operating in conjunction with any other antenna or transmitter.
FCC Notice and Cautions
Any changes or modifications to this device not expressly approved by Thinkify, LLC could
void the user's authority to operate the equipment.
Compliance FCC Part 90
Thinkify RFID readers that have been configured by the manufacturer for the FCC Part 90 regulatory
region. Pursuant to FCC Part 90.205, the Thinkify RFID reader’s radiated power is limited to +20dBm
(100 mWatts) ERP (Effective Radiated Power). Under all conditions, the Thinkify RFID reader will
operate will below the maximum limit of Part 90 devices.
Acceptable Frequencies
917 to 923.25 MHz
Operation outside of these limits in Japan is not authorized!
Three preferred frequencies are:
917 MHz
920 MHz
923.25 MHz
Copyright 2014 Thinkify LLC. All Rights Reserved.
Thinkify, LLC, 18450 Technology Drive, Suite E1, Morgan Hill, Ca. 95037, www.thinkifyit.com 408-782-7111