User Guide
Table Of Contents
- Note Regarding RF Exposure.
- FCC Notice and Cautions
- Compliance FCC Part 90
- Acceptable Frequencies
- Migrating from Thinkify HSP2_0 to HSP3_0 firmware
- Ethernet Communication between HOST and THINKIFY HSP3.0
- Output and Status Messaging in the Thinkify HSP3.0 system
- IO and Timing control in the Thinkify HSP3.0 System
- System Type Functions and control in the Thinkify HSP3.0 system
- Using the LOCK function in Thinkify HSP3.0
- Controlling the programming list database in the Thinkify HSP 3.0 system
Only one termination message is given indicating status
ENCDONE=ALL<statusbyte>,OPN<statusbyte>,TID<statusbyte>,EPC<statusbyte>,KIL
: <statusbyte>,ACC: <statusbyte>,USR: <statusbyte>,PCW<statusbyte>,LCK:
<statusbyte><CRLF>
The values and meanings of the statusbyte fields is given at the end of this document.
If the SYSTEMTYPE is STANDALONE
If the OPEN of the tag was successful the first message sent will be the EPC data read
during the ACK command.
Format --
ENTRYEPC=<ASCII HEX><CRLF>
If the READ of the TID was successful (of course this only occurs if the OPEN was
successful) the next message will be the data read from this memory area.
Format --
TID=<ASCIIHEX><CRLF>
or
TID= READFAIL<CRLF>
If all the programming operation enabled by the current programming database structure
are successful, the EPC memory will be read after all programming operations complete
and the status of this read will be reported.
Format --
EXITEPC=<ASCIIHEX><CRLF>
or
EXITEPC = READFAIL<CRLF>
Finally the termination status message will be sent
STADONE=ALL<statusbyte>,OPN<statusbyte>,TID<statusbyte>,EPC<statusbyte>,KIL
: <statusbyte>,ACC: <statusbyte>,USR: <statusbyte>,PCW<statusbyte>,LCK:
<statusbyte><CRLF>
Status message byte meanings and values
Copyright 2014 Thinkify LLC. All Rights Reserved.
Thinkify, LLC, 18450 Technology Drive, Suite E1, Morgan Hill, Ca. 95037, www.thinkifyit.com 408-782-7111