Setup Guide
Table Of Contents
- Notices
- About Thinkify, LLC
- A Quick RFID Introduction
- Thinkify Reader Protocol Overview
- Command Reference
- Summary
- "A" – RX Amplifier Control
- "BOOTLOADER" – Enter Bootloader
- "C" – Low-Level Chip Control Registers
- "F" – RX Filter Control
- "G" – GPIO Settings
- “I” – Inventory Control
- "K" – Kill, Lock, Access Descriptors
- “M" – MASK / SELECT control
- “NM" – Macro Control
- "P" – PROTOCOL control (Gen2 Air protocol)
- "R" – RF Control
- "RP" and "RM" – Multiplexing (Antenna Control)
- "T" – Initiate INVENTORY
- "X" – eXtra Data Read and Write Descriptor Control
Label:
Test Modulation Modes:
Test modulation modes, to insure that the TR100 when included within the host device remains
compliant, are available from Thinkify upon request.
Revision History
7 October 2020 - drafted the TR100 Setup and User's Manual.
7 January 2021 – removed outdated output power table
27 January 2021 – added required FCC and IC integration instructions
7