Setup Guide

Modular Use, Procedures, and Integration Instructions
Sole Transmitter:
This module is to be used alone for the purposes of RFID. This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter. If there are other
transmitters co-operational in the immediate vicinity of the TR100 module or if there are are
any questions about co-operational transmitters please contact Thinkify.
Equipment Authorization:
The end user is responsible for obtaining any and all required equipment authorization for the
applicable unintentional radiator functions (part 15 sub-part B), of the host product.
Testing:
The end user will perform testing on the host product with the TR100 module operating to
confirm that the final product meets all FCC requirements. Testing requirements are further
defined in the following:
https://apps.fcc.gov/kdb/GetAttachment.html?id=bNCiEdkFEKnHsZF9GHCNdg%3D
%3D&desc=996369%20D04%20Module%20Integration%20Guide
%20V02&tracking_number=44637
Label:
The Thinkify label should not be removed. End users are responsible for the continued
compliance of their modules to the FCC and IC rules. Host product manufacturers must provide
a physical or e-labelstating“Contains FCC ID” with their finished product. See Guidelines for
Labeling and User Information for RF Devices in KDB Publication 784748. The module is
labeled with the following identification:
FCC ID: XE2C
IC: 9962A-100
The host device in which the module is integrated into should be labeled with the following
identification:
Contains FCC ID: XE2C
Contains IC: 9962A-100
5