Setup Guide
Table Of Contents
- Notices
- About Thinkify, LLC
- A Quick RFID Introduction
- Thinkify Reader Protocol Overview
- Command Reference
- Summary
- "A" – RX Amplifier Control
- "BOOTLOADER" – Enter Bootloader
- "C" – Low-Level Chip Control Registers
- "F" – RX Filter Control
- "G" – GPIO Settings
- “I” – Inventory Control
- "K" – Kill, Lock, Access Descriptors
- “M" – MASK / SELECT control
- “NM" – Macro Control
- "P" – PROTOCOL control (Gen2 Air protocol)
- "R" – RF Control
- "RP" and "RM" – Multiplexing (Antenna Control)
- "T" – Initiate INVENTORY
- "X" – eXtra Data Read and Write Descriptor Control
“NM" – Macro Control
“NM" – Macro Control
The Macro is a place to store and save reader settings that are preserved even after a device
power off/on or BRS (reset command).
Sub
Command
Description
NMA
Macro Append - add to the end of the macro list without erasing the rest (so you can add settings
without typing the whole thing over)
NMC
Erase the macro list
NMP
Play the macro list (will be done automatically on reset).
NMW
Erase current macro list first, type END to stop the writing operation.
NMR
Read the current macro list
Macro Append Macro Write
READY>nmaag5 READY>nmw
APPEND SUCCESS USER MACROERASE
USER MACRORECORD START
READY>nmr ag5
START USER MACROREAD p022
AG5 end
END USER MACRO WRITE COMPLETE
USER MACRO END
Macro Clear
READY>nmc
USER MACROERASE
READY>nmr
START USER MACROREAD
END
USER MACRO END
37