Setup Guide
Table Of Contents
- Notices
- About Thinkify, LLC
- A Quick RFID Introduction
- Thinkify Reader Protocol Overview
- Command Reference
- Summary
- "A" – RX Amplifier Control
- "BOOTLOADER" – Enter Bootloader
- "C" – Low-Level Chip Control Registers
- "F" – RX Filter Control
- "G" – GPIO Settings
- “I” – Inventory Control
- "K" – Kill, Lock, Access Descriptors
- “M" – MASK / SELECT control
- “NM" – Macro Control
- "P" – PROTOCOL control (Gen2 Air protocol)
- "R" – RF Control
- "RP" and "RM" – Multiplexing (Antenna Control)
- "T" – Initiate INVENTORY
- "X" – eXtra Data Read and Write Descriptor Control
"C" – Low-Level Chip Control Registers
"C" – Low-Level Chip Control Registers
C[<SUBCMD>[<PARAMS>]] – See table, below.
C<ADDR><VAL> – Sets a register.
ADDR may be one or two nibbles.
VAL may be 2 or 6 nibbles.
The “C” command and sub-commands are used to set and get the low-level control registers
in the AM3392 chip. (This is an engineering command.)
Sub-Commands
Sub
Command Description
Legal Values
for SET
C
Report all control registers.
Register Description
0x00 Status control (byte)
0x01 Protocol control (byte)
0x02 TX option (byte)
0x03 RX option (byte)
0x04 TRcal Low reg (byte)
0x05 TRCal Hi reg (byte)
0x06 TX Delay (byte)
0x07 RX No Resp Wait (byte)
0x08 RX Wait (T1) (byte)
0x09 RX Filt Reg (byte)
0x0A RX Spec2 (byte)
0x0B Regulator and RF control (byte)
0x0C -
0x0D IRQ Mask (byte)
0x0E
0x0F
0x10
0x11 Test Select Reg (byte)
0x12 Test Setting reg (word)
-c
22