Setup Guide
Table Of Contents
- Notices
- About Thinkify, LLC
- A Quick RFID Introduction
- Thinkify Reader Protocol Overview
- Command Reference
- Summary
- "A" – RX Amplifier Control
- "BOOTLOADER" – Enter Bootloader
- "C" – Low-Level Chip Control Registers
- "F" – RX Filter Control
- "G" – GPIO Settings
- “I” – Inventory Control
- "K" – Kill, Lock, Access Descriptors
- “M" – MASK / SELECT control
- “NM" – Macro Control
- "P" – PROTOCOL control (Gen2 Air protocol)
- "R" – RF Control
- "RP" and "RM" – Multiplexing (Antenna Control)
- "T" – Initiate INVENTORY
- "X" – eXtra Data Read and Write Descriptor Control
Command Reference
Command Reference
Summary
Main Command Description Command Group
A
RX Amplifier Control Engineering / Test
B
Enter Bootloader System
C
Low-Level Chip Registers Engineering / Test
D
Diagnostic Functions Engineering / Test
F
RX Filter Control Engineering / Test
G
GPIO Control GPIO Control and Triggering
I
Inventory Control Tag Commands
K
Kill / Access Data Descriptors Tag Commands
L
Low-Level Tests Engineering / Test
M
Tag Masking Tag Commands
P
Protocol Air Interface Radio Control
R
RF Control Radio Control
S
Status Functions System
T
Perform Tag Inventory Tag Commands
V
Get Firmware Version (Read Only) System
X
eXtra Read / Write Data Descriptors Tag Commands
19