User's Manual

operating instructions Base Station2
6
English
Routine care:
ALWAYS disconnect Base Station2 from the charger or the mains
before cleaning!
Cleaning notes:
Use a soft cloth moistened with a weak solution of a mild detergent and wa-
ter to clean Base Station2’s exterior.
Do not use compressed air to clean Base Station2 or its components.
Initial operation
Before installing Base Station2 turn the included antenna clockwise until it
is stopped by the screw extension. This can be done manually.
Base Station2 is intended for setup indoors. It can be installed in a standing
position or wall- or ceiling-mounted (upside down).
For optimum performance avoid installing Base Station2 near metallic ob-
jects.
The status display is controlled by means of the Oman.exe program.
For wall-mounting or attaching an expansion module (option), remove Base
Station2’s antenna by rotating it counter-clockwise. Then remove the screw
by turning it counter-clockwise (can be done manually) and lift the plastic
cover and the illuminated ring (status display) from the housing. The base
plate has two holes for wall-mounting. Installation of the expansion module
is described in its operating instructions manual.
Additional information on initial operation can be found in the installation
instructions for the ORDERMAN

system.
Tip
Caution