User's Manual

  
,




The following settings can be chosen in the ORDERMAN



setup.
Touch calibration set-up
Touch calib.
First, touch the four crosses on the display using the Orderman

touch pen. Followed
by the four points on the menu card (the sequence will be shown in the display).
Setting the contrast and background lighting
Display
Using the ORDERMAN

touch pen, pull the bar in the bar area to change the con-
trast ("contrast") and the brightness of the
display ("backlight").
Setting the automatic switch off times
Time out
In the “Power Off” bar field, the switch off time (seconds) can be set by pulling the
bar, after which the device will switch off automatically, if it is not operated. In the
“Back-Light” bar field, pull the bar to set the time (seconds) after which the back
lighting (display and menu card area) will switch off, if the device is not operated.
Test of the equipment’s basic functions
Hw Test
In this menu you can test your equipment’s basic functions i.e. Bluetooth interface
and the touch’s function. You can test all options existing in the equipment (OR-
DERMAN

Card Swipe,
ORDERMAN

Legic and ISO Transponder Reader as well as the ORDERMAN

Or-
der Card) too.
Software - Versions
Versions
In this menu, the software versions and the name of the menu card (BLY) are shown.

