Users Manual

Modification statement
Things on Edge has not approved any changes or modifications to this device by the user.
Any changes or modifications could void the user’s authority to operate the equipment.
Interference statement
This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
RF exposure compliance statement:
This device has been evaluated to meet the general RF exposure requirement.
The antenna should be installed and operated with minimum distance of 20cm between the radiator and
your body. Antenna gain must be below 0 dBi.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The host end product must include a user manual that clearly defines operating requirements and
conditions that must be observed to ensure compliance with current FCC RF exposure guidelines.
For portable devices, in addition to above, a separate approval is required to satisfy the SAR
requirements of FCC Part 2.1093.
If the device is used for other equipment that separate approval is required for all other operating
configurations, including portable configurations with respect to 2.1093 and different antenna
configurations.
Labelling Requirements for the Host device
The host device shall be properly labelled to identify the modules within the host device. The certification
label of the module shall be clearly visible at all times when installed in the host device, otherwise the
host device must be labelled to display the FCC ID of the module, preceded by the words
"Contains transmitter module", or the word "Contains", or similar wording expressing the same meaning,
as follows:
Cricket
MODEL: REV 1.0
FCC ID: 2AW7I-VEV
The host OEM user manual must also contain clear instructions on how end users canfind and/or access
the module and the FCC ID .
Cricket
MODEL: REV 1.0
FCC ID: 2AW7I-VEV
OEM Statement
a. The module manufacturer must show how compliance can be demonstrated only for specific host or
hosts
b. The module manufacturer must limit the applicable operating conditions in which transmitter will be
used, and
c. The module manufacturer must disclose that only the module grantee can make the evaluation that the
module is compliant in the host. When the module grantee either refuses to make this evaluation, or does
not think it is necessary, the module certification is rendered invalid for use in the host, and the host
manufacturer has no choice other than to use a different module, or take responsibility (§ 2.929) and
obtain a new FCC ID for the product.
d. The module manufacturer must provide the host manufacturer with the following requirements:
e. The host manufacturer is responsible for additional testing to verify compliance as composite system.
When testing the host device for compliance with Part 15 Subpart B, the host manufacturer is required to
show compliance with Part 15 Subpart B while the transmitter module(s) are installed and operating. The
modules should be transmitting and the evaluation should confirm that the module’s intentional emissions
are compliant (i.e. fundamental and out of band emissions).