Owner manual

Configuring Readers
68 Level 2 API
/reader/uri
Type: String
Default value: From reader
Writable: no
Products: all
Gets the URI string used to connect to the reader from the
Reader Object.
/reader/userConfig
Type: SerialReader.UserConfigOp
Default value: null
Writable: yes
Products: M6e
Enables M6e configuration Saving and Restoring. See
Save and Restore Configuration.
/reader/antenna
/reader/antenna/checkPort
Type: boolean
Default value: From reader
Writable: yes
Products: M5e (and derived products), M6e, M6
Controls whether the reader checks each antenna port for a connected antenna before
using it for transmission. Make sure all connected antennas are detectable before turning
this on.
On the M6 this is enabled by default and also turns antenna detection on at boot time.
This results in the Web Interface | Status page reflecting which antennas are connected,
detectable and available for usage. If disabled then antennas to transmit on must always
be explicitly specified.