Installation Manual

MAINTENANCE & SERVICING

• Shut off gas supply at isolating valve, switch off electric supply and

ensure all parts are cool before cleaning or servicing

• All servicing must be carried out by an approved competent person.

• After each service the appliance must be checked for gas soundness

• This appliance must not be modified or adjusted unless authorized

and carried out by the manufacturer or his representative. No parts

other than those supplied by the manufacturer should be used on

this appliance.

• If the supply cord is damaged, it must only be replaced by the

manufacturer or his representative in order to avoid a hazard.

This appliance needs little maintenance other than cleaning. All parts should be cleaned using

warm soapy water. Do not use abrasive cleaners, steel wool or cleansing powders. When

cleaning the burner ring it is essential to ensure that the holes do not become blocked. The

control knobs are a push fit and can be removed for cleaning.

Who to Contact

For service, please contact your authorised local Service Agent giving full details of the model,

serial number and date of purchase.

Manufactured by: THETFORD Limited.

Unit 19 Oakham Drive, Parkwood Industrial Estate,

Rutland Road, Sheffield. S3 9QX. England.

1. Remove appliance from housing

Shut off both gas & electric supply. Lift the glass lid and remove 2 screws from either side

of the hob surround trim and close the lid. Open the grill door, oven door and lower door,

remove the fixing screws – note the appliance can either be front or side fixed, see under

Fixing, page 11. Carefully slide the appliance out one third to gain access and disconnect

the gas supply. Check for any possible snagging of wires or pipes. If OK, lift appliance out

onto a suitable surface

2. Remove the hob surface

Shut off both gas & electric supply. Lift off the pan rest and remove the two screws securing

each burner cap and spreader. Carefully remove front fascia by removing all the push on

control knobs and unscrewing the 2 recessed fixing nuts. Remove the 2 standoff studs

securing each burner cup. Remove the 2 screws securing the pressing to the rear box

section. Grasp the hob by the angled front face, carefully lift the hob surface tilting from the

front to allow rear edge to unhook from rear box section. The hob surface should be put

onto a suitable surface.

3. Control replacement –Hob and Grill

Shut off both gas & electric supply. Remove the hob surface (2). Unscrew the

corresponding pipe and thermocouple and remove from the control.

Remove the locknut from the front of the control panel. Disengage the control from the gas

rail and remove.

4. Control replacement - Oven thermostat

Shut off both gas & electric supply. Remove appliance from housing (1). Remove the hob

surface (2). Open the oven door and unscrew the 2 screws holding the thermostat probe in

position and push the probe back out through the hole in the rear of oven. Remove the

retaining screws from on top and underneath the control and remove from the gas rail.

Remove the fittings off the old control and fit on the replacement.