BUILD IN APPLIANCES FOR USE WITH PROPANE GAS MODELS S~OH70000Z - TRIPLEX S~OH71000Z – TRIPLEX DUAL FUEL USER AND INSTALLATION INSTRUCTIONS PLEASE READ THOROUGHLY AND KEEP FOR FUTURE PCC 1265Z – Issue 7 FOR USE IN AUSTRALIA THETFORD AUSTRALIA PTY LTD 41 LARA WAY CAMPBELLFIELD VIC TEL: 03 9358 0700 FAX: 03 9357 7060
SPECIFICATION Model Range External Dimensions, mm (HxWxD) Oven Capacity, litres No.
INTRODUCTION In your own interest of safety, gas appliances should be installed by competent persons. Failure to install the appliance correctly could invalidate any warranty or liability claims. This appliance shall be installed in accordance with the manufacturers installation instructions, local gas fitting regulations, municipal building codes, AG5601 and any other relevant statutory regulations. Data label.
OPERATION WARNING • The appliance is not intended for use by young children or infirm persons, without supervision • Young children should be supervised to ensure they do not play with the appliance. • Glass lids may shatter when heated. Turn off all burners before shutting the lid • Spillage on the surface of the lid should be removed before opening the lid. Burner operation The burners on this appliance have fixed aeration and no adjustment is required.
OPERATION WARNING • Glass lids may shatter when heated. Turn off the hotplate and allow it to cool before closing the glass lid. • Remove all spillage from the surface of the glass lid before opening. Using the Electric Hotplate Ensure the electricity is switched on. The hotplate control is numbered from 1 to 6. To turn it on, rotate the knob either clockwise or anti-clockwise to the required position. Position 1 is the coolest setting.
OPERATION IMPORTANT • The grill MUST only be used with the door open. • When grilling the oven shelf should be located on the middle runner. • The heat deflector below the fascia should be pulled out prior to lighting the grill. Never adjust the heat deflector position without using hand Using the Grill 1. Ensure gas cylinder/supply is connected and turned on. In the event of a gas smell turn off at gas cylinder/mains and contact supplier. 2.
OPERATION WARNING When cooking always ensure young children are kept away. Using the Oven 1. Ensure gas cylinder/supply is connected and turned on. In the event of a gas smell turn off at gas cylinder/mains and contact supplier. 2. To light: Open door, push in the control knob and turn to full rate (Gas Mark 9, 240°C). Hold 3. 4. 5. 6. 7. a lighted match or taper to the burner and push the control knob in and hold.
OPERATION Do's and Don'ts DO Read the user instructions carefully before first use of the appliance. DO Allow the oven to heat before using for the first time, in order to expel any smells before the introduction of food. DO Clean the appliance regularly. DO Remove spills as soon as they occur. DO Always use oven gloves when removing food shelves and trays from the oven. DO Check that controls are in the off position when finished. DO NOT Allow children near the cooker when in use.
INSTALLATION Regulations and Standards In your own interest of safety, gas appliances should be installed by competent persons. Failure to install the appliance correctly could invalidate any warranty or liability claims. This appliance shall be installed in accordance with the manufacturers installation instructions, local gas fitting regulations, municipal building codes, AG5601 and any other relevant statutory regulations. Data label.
INSTALLATION IMPORTANT • • • This appliance must be installed into an aperture, sealed off at either side in order to prevent draughts from adjoining cupboards/vents. Ensure that air vents and gas escape holes are kept clear, holes for cables and pipes must be sized to minimize air leakage between compartments. Under no circumstances should the ventilation hole exceed the maximum size specified. Low level vents in adjacent compartments are permitted.
INSTALLATION Connection - Electrical The appliance is supplied with a power cord and plug which must be connected to a double pole switched mains supply, with 3mm minimum contact separation at all poles. Any excess power cord MUST be routed away from the appliance and not come into contact with the appliance or hang loose into a lower compartment. When satisfied with the appliance, please instruct the user on the correct method of operation.
MAINTENANCE & SERVICING IMPORTANT • All servicing must be carried out by an approved competent person. • After each service the appliance must be checked for gas soundness This appliance needs little maintenance other than cleaning. All parts should be cleaned using warm soapy water. Do not use abrasive cleaners, steel wool or cleansing powders. When cleaning the burner ring it is essential to ensure that the holes do not become blocked. The control knobs are a push fit and can be removed for cleaning.
MAINTENANCE AND SERVICING 4. Control replacement Hob controls Disconnect from gas supply (1). Remove hob surface (2). Unscrew the corresponding pipe and thermocouple and remove from the control. Open the oven door and unscrew the 2 screws holding the thermostat probe in position and push the probe back out through the hole in the rear of oven. Remove the retaining screws from on top and underneath the control. Disconnect the inlet pipe and two burner supply pipes.
